Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Roofing: The San Antonio Owner’s Guide
We stock and install Mr-Glass-compatible roofing parts across San Antonio, with most roof repairs running $400 – $1,800 installed depending on what failed. A complete Mr-Glass roof replacement on a typical San Antonio home lands between $8,000 and $20,000. We keep the most common Mr-Glass roofing components on our trucks, so in many cases we can handle the repair in a single visit.
Most San Antonio homeowners discover a Mr-Glass roofing part has failed the hard way: a water stain spreads across the ceiling after a Hill Country thunderstorm, or a neighbor mentions seeing a lifted flashing edge from across the street. Sometimes it’s quieter than that. Crumbling sealant around a pipe boot, a shingle tab that cracked in July heat and finally let go in an October wind gust. By the time you notice, water has usually been working on the problem for weeks. The good news is that Mr-Glass roofing systems are built in distinct, identifiable components, which means a failed part can usually be isolated and replaced without tearing off the whole roof.
Which Mr-Glass Models This Applies To
Mr-Glass roofing components fall into a few distinct series, and the wrong part is worse than no part at all. The Mr-Glass Architectural series uses a heavier laminated shingle profile that runs slightly wider than standard three-tab, so if a patch is cut from the wrong stock, the seams won’t line up and water finds the gap. The Mr-Glass Classic series is the traditional three-tab line, and while it’s more common, the color lots vary enough that a mis-matched bundle is visible from the curb. There’s also a Mr-Glass Ridge and Hip component line with its own sizing, and that’s where we see the most mix-ups on older San Antonio roofs.
Here’s the compatibility gotcha we run into weekly: a Mr-Glass roof installed before roughly 2012 may have used a discontinued fastener pattern. If you’re adding flashing or replacing a section, the new part often needs a retrofit clip or the fastener line won’t seat. We know to check for that before quoting, and it keeps the job from becoming a two-trip repair. As for OEM versus aftermarket: we install OEM Mr-Glass components when they’re still manufactured and available, because the color match and wind rating stay true to the original roof. For discontinued parts, we source quality aftermarket equivalents that match the profile and fastener spacing. Mason Remodeling Co San Antonio is an independent service provider, not affiliated with Mr-Glass, which means we carry what works rather than what a single brand tells us to carry. We also stock parts for KraftMaid, Cambria, and Silestone for our broader remodeling work.
Styles & brands we work with
Signs Your Mr-Glass Roofing Is Failing
- Water staining on ceilings or walls. This is the late-stage sign. By the time a stain shows inside, water has already saturated the decking beneath the Mr-Glass shingles or worked past a failed flashing point.
- Lifted or curled shingle tabs. San Antonio’s summer heat bakes the adhesive strip that bonds shingle tabs. Once the bond breaks, wind gets under the tab and folds it back, exposing the nail line to every rain that follows.
- Missing granules in the gutters. Mr-Glass shingles shed granules as they age, but a sudden heavy accumulation means the shingle surface is degrading faster than it should, usually from hail or prolonged sun exposure on a south-facing slope.
- Dark spots or algae streaks. San Antonio’s humidity and shade from mature oaks create the conditions for algae growth. The streaks are cosmetic at first, but the retained moisture shortens the shingle’s working life.
- Exposed or popped nails near ridges and vents. A popped nail means the shingle above it has shifted or the decking has flexed. That’s an open channel for water, and it’s one of the fastest, cheapest repairs if caught before water spreads.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
A Mr-Glass roof repair in San Antonio typically runs $400 – $1,800, depending on whether we’re replacing a few shingles, resealing a pipe boot, rebuilding flashing, or reworking a section of ridge. A full Mr-Glass roof replacement runs $8,000 – $20,000, with the spread driven by roof size, pitch, the condition of the existing decking, and whether we’re pulling off one layer or two. Here’s how the common jobs break down:
- Shingle replacement (patch): $400 – $900
- Pipe boot or vent reseal: $400 – $850
- Flashing replacement (chimney, wall, or valley): $600 – $1,500
- Ridge cap repair or replacement: $500 – $1,100
- Full Mr-Glass roof replacement: $8,000 – $20,000
Every quote is a written price before any work starts, parts and labor separated so you can see exactly what you’re paying for. We don’t do verbal estimates that grow later. The 365-Day Done Right Promise applies here too: if our repair isn’t right within a year, we return and make it right at no cost to you.
DIY or Call Us?
We’ll be straight with you. For a ground-level visual inspection, go ahead and look: check for lifted tabs, missing granules in the gutter, daylight showing through roof vents. That will tell you whether you need to make a call. What we don’t recommend is getting on a San Antonio roof without the right equipment. Steep pitches, tile roofs that shatter underfoot, and early-morning dew that turns a shingle roof into a slip hazard put experienced roofers in the hospital every season. There’s also the matter of getting the repair wrong: a homeowner-patched Mr-Glass section that leaks again often costs more to fix correctly than the original repair would have.
If you’ve spotted the problem and want it handled by a crew that’s identity-verified before they ever walk through your gate, call (254) 269-5071. We’ll give you a written price and a time that holds. Know who’s coming, know what it costs, know it’s covered – that’s the whole job before the job starts.
FAQs
A Mr-Glass architectural shingle roof in San Antonio realistically lasts 15 – 20 years, which is on the shorter end of the lifetime range due to the combination of intense sun, hail events, and high humidity that accelerates adhesive breakdown. Many factors affect this, including attic ventilation and whether the roof was properly installed originally. Call (254) 269-5071 and we’ll give you an honest read on your specific roof.
Yes, most individual Mr-Glass roof components can be repaired or replaced without touching the rest of the roof, as long as the failure is localized. Flashing, pipe boots, ridge caps, and small shingle patches are all standard repairs. If the failure is widespread or the shingles are near the end of their life, a full replacement makes more financial sense. We’ll tell you which one applies to your roof when we inspect it.
Most repair jobs take 2 – 4 hours on site, including setup, repair, and cleanup. Full roof replacements typically take 1 – 3 days depending on the size and pitch of the roof. We’ll give you a written estimate of time when we quote the work.
We stock the most common Mr-Glass-compatible shingle profiles, ridge components, flashing, and sealants on our trucks, so a straightforward repair can often be completed the same day. If your roof needs a discontinued color or a specialty component, we’ll order it and give you a solid arrival date before any work is scheduled.
Written by Isaac Pruett, Owner, Mason Remodeling Co San Antonio at Mason Remodeling Co San Antonio, serving San Antonio and nearby areas.
