Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cambria Fence Installation: The San Antonio Owner’s Guide
Cambria fence installation in San Antonio typically runs $3,500 to $9,000 installed, depending on the fence material, linear footage, and whether we’re replacing existing posts or setting new ones. Most owners discover they need this work when a windstorm snaps a post at ground level, or when the gate starts dragging and won’t latch. We stock the common Cambria-compatible hardware and fence components on our trucks, so when we show up for the estimate, we can usually tell you exactly what’s needed that same visit.
The part that fails first in San Antonio is almost always the post, not the panel. Our clay-heavy soil expands and contracts through wet and dry cycles, and posts set without proper drainage eventually heave or rot at the base. If your fence looks fine from the street but leans hard after a rain, check the post line before you blame the panels.
Which Cambria Models This Applies To
Cambria doesn’t manufacture fence panels, but many San Antonio homes built or remodeled with Cambria countertops also feature fence systems that builders matched to the Cambria aesthetic and hardware. The fence components we install are Cambria-style compatible: aluminum posts, steel post inserts, gate hardware, and decorative toppers that match the clean, modern lines of a Cambria kitchen or bath. If your fence was installed alongside a Cambria project, you’ll usually find the original builder’s mark stamped inside the gate latch or on the post cap.
The compatibility gotcha: Cambria-style fence posts come in two internal dimensions, 2 3/8-inch and 2 1/2-inch outside diameter. If you buy a replacement post off the shelf without measuring, you’ll end up with a gate that binds or a post cap that won’t seat. We measure every post on site before ordering. On the OEM versus aftermarket question, for most Cambria-style fences we recommend powder-coated steel posts from the same supplier the builder used, because San Antonio’s UV and humidity will fade an unbranded aluminum post within three years. The hardware is where aftermarket makes sense: a good stainless steel gate hinge at $18 will outlast a $40 decorative hinge that rusts through at the weld point.
Styles & brands we work with
Signs Your Cambria Fence Installation Is Failing
- Gate drags or won’t latch at all. This usually means the post has shifted out of plumb, not that the latch is broken. Loosening and re-setting the post is the real fix; replacing the latch just buys a few months.
- Post leans noticeably after rain. Clay soil in San Antonio expands when wet, and a post set in concrete without a gravel base will heave. You’ll see the lean get worse each wet season until the post finally snaps.
- White powder or flaking at the post base. That’s aluminum corrosion from standing water. It starts as a cosmetic issue and ends as a structural one when the post walls thin out.
- Panels rattle loudly in the wind. Loose panel clips or worn post inserts let the panel move. Left alone, the panel will scratch the post finish and eventually work its way out of the channel.
- Screws pulling out of the gate frame. This means the hinge screws have stripped the post or the gate frame. A wood block inside the post can buy time, but replacement hardware with proper backing plates is the permanent fix.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed Cambria-style fence replacement in San Antonio runs $3,500 to $9,000 for a typical residential run. Here’s what drives the spread:
- Post replacement only: $3,500 to $5,000 for a standard yard with 10 to 15 posts, including concrete removal, new post setting, and rehanging existing panels.
- Full fence replacement with panels: $6,000 to $9,000, including new posts, panels, hardware, gate rebuild, and haul-off of the old fence.
- Gate-only rebuild: usually $800 to $1,500 as part of a larger job, depending on gate width and whether the post needs resetting.
Every quote we write for Cambria fence work in San Antonio includes parts, labor, concrete, hardware, and haul-off in one line-item price. You get that price in writing before we start, and it doesn’t change unless you change the scope. The work is covered by our 365-Day Done Right Promise: if the fence shifts, the gate binds, or anything we installed fails within a year of completion, we come back and make it right at no charge.
DIY or Call Us?
You can safely check a few things yourself: look for standing water at the post base, push gently on each post to feel for movement, and note whether the gate gap widens at the top or bottom. What you shouldn’t try is pulling a post that’s set in concrete or rehanging a heavy gate on your own. A 60-pound gate panel under tension can swing hard enough to break a hand, and a post that snaps while you’re digging around it can fall toward you.
If the post is loose but the fence is otherwise sound, that’s a half-day fix for us and doesn’t require replacing everything. Call (254) 269-5071 and we’ll come look. The estimate is free, and you’ll know the exact cost before you decide anything.
FAQs
A properly set steel-post fence with powder-coated aluminum panels lasts 20 to 25 years in San Antonio, but the gate hardware usually needs replacement every 8 to 10 years. Our climate’s main issue is soil movement, not sun damage, so proper post setting matters more than panel material. Call (254) 269-5071 if you want us to check your post depth and drainage before you commit to a full replacement.
Sometimes, but only if the post itself is still sound. We can straighten and re-set a post that has shifted in the soil, but if the post wall has corroded or cracked at the base, it needs to come out. In San Antonio’s clay soil, we almost always add a deeper gravel base and a concrete collar when we reset a post, which addresses the movement problem rather than repeating it. Call (254) 269-5071 for a free assessment.
A standard residential fence replacement in San Antonio takes two to three days from post removal to final gate adjustment. Post-only replacement is usually one day. We schedule the work, show you exactly who is coming before they arrive, and you’ll never wonder when the crew will show up.
We stock the common hardware on our trucks: gate hinges, latches, post caps, panel clips, and post inserts in both standard sizes. For full post and panel replacement, we order from our local supplier in San Antonio, which usually delivers to us within three business days. If you’re matching an existing fence color or style, we take a sample to the supplier to get the match right. We install parts from KraftMaid, Silestone, and Kohler as well when the project involves adjacent work on the home.
Written by Isaac Pruett, Owner, Mason Remodeling Co San Antonio at Mason Remodeling Co San Antonio, serving San Antonio and nearby areas.
